Fluorescein

This is a special dye used in eye exams. Doctors put a drop in your eye, and it helps them see the blood vessels in your retina, which is the back part of your eye. It helps check for conditions like glaucoma or macular degeneration.

Brand names:Fluor-I-Strip A.T., Fluorescite, Fluorets
Medication

What people taking Fluorescein report

Every report comes from a Lived member, sent anonymously.

NameHow it went

No reports yet

Add what worked for you with the search bar below

About Fluorescein

What It's For

Fluorescein is an orange dye that eye specialists use to see problems they could not otherwise see. It does not treat anything; it is a diagnostic aid, and it is used in two quite different ways. As an injection into a vein, sold as Fluorescite and AK-Fluor as well as in generic form, it is used for fluorescein angiography, a test that photographs blood flowing through the retina (the light-sensing layer at the back of the eye), the layer of vessels beneath it called the choroid, and the iris. The test helps diagnose and plan treatment for conditions such as diabetic retinopathy, wet macular degeneration and blocked retinal veins or arteries, and it shows how well treatment is working. On the surface of the eye, fluorescein is applied from a moistened paper strip or as an eye drop, often combined with a numbing medicine. This fluorescein eye stain reveals scratches, foreign bodies, infection and dry patches on the cornea (the clear front window of the eye), helps check how contact lenses fit, and is used during one common way of measuring eye pressure for glaucoma.

How It Works

Fluorescein glows. When blue light shines on it, it gives off a bright yellow-green light, and eye cameras and examination lamps are fitted with filters that capture that glow. After an injection into the arm, the dye usually reaches the blood vessels of the eye within 7 to 14 seconds. A camera takes a rapid series of photographs as it flows through. Healthy vessels hold the dye inside them, so the pictures show where blood flow is blocked, where vessels are leaking, and where fragile new vessels have grown. On the eye surface, the dye spreads through the tear film when you blink. Healthy cornea does not hold on to it, but areas where the surface layer is scratched or damaged take up the stain and glow green under the blue light. The size, shape and position of the staining point the examiner toward the likely cause.

Dosage & Administration

For angiography, the dye is given once, as part of the test. The usual adult dose is 500 mg (5 mL of a 10% solution) injected quickly into a vein, usually at the inside of the elbow; children receive a dose based on body weight. Some clinics with more sensitive cameras use a smaller amount. Drops are first used to widen the pupils, and a set of photographs is usually taken before the dye goes in. For an eye stain, the examiner wets the tip of a sterile strip and touches it briefly to the inside of the lower lid, or places one or two drops in the eye, then asks you to blink a few times. Contact lenses are removed first. Fluorescein is given only by an eye care professional or trained staff, so there is no dose to manage at home.

Side Effects

After an injection, a yellowish tint to the skin is expected and usually fades within 6 to 12 hours. Urine turns bright yellow or orange and usually returns to normal within 24 to 36 hours. Some people notice a strong taste or a brief warm feeling. Nausea, and sometimes vomiting, is the most common unpleasant effect. It typically starts within a minute or so of the injection and usually passes within about 10 minutes. In a large study, about 1 in 20 angiograms was followed by some reaction, mostly nausea; itching or hives occurred in about 1 in 200. Severe allergic reactions, including wheezing and anaphylaxis, are rare, and very rare deaths have been reported. Tell the staff immediately if you feel itchy, develop hives, feel faint or have trouble breathing during or after the injection; clinics that perform angiography keep emergency treatment on hand for this reason. The solution is strongly alkaline, so if it leaks out of the vein into the surrounding tissue it can cause intense pain and, occasionally, lasting skin or nerve damage. Say so at once if the arm burns or hurts while the dye is going in, so the injection can be stopped. The eye stain itself causes little more than brief stinging, and the dye can leave a temporary yellow mark on skin or clothing. Drops that also contain a numbing medicine can sting, burn or make the eye red for a short time.

Interactions & Warnings

The main question before an angiogram is whether you have reacted to fluorescein before. People who had a reaction to an earlier injection are far more likely to react again (in one study, close to half did), and severe reactions are more common in people with allergies such as hives, asthma, eczema or hay fever. Mention these, and any reaction to other dyes or medicines, so the team can decide whether to proceed, adjust the plan or watch more closely. A skin test is sometimes done, but a negative result does not rule out a reaction. There is limited information about fluorescein injection in pregnancy, so it is generally used only when the test is clearly needed. The dye passes into breast milk for up to four days after an injection. Tell the team if you are pregnant, might be, or are breastfeeding so you can discuss timing and how to handle breastfeeding afterward. After drops that contain a numbing medicine, the eye cannot feel injury, so avoid touching or rubbing it for about 20 minutes. Numbing eye drops are for use in the clinic only; repeated use can damage the cornea.

What to Expect

For an angiogram, you sit with your chin on a rest and your forehead against a bar while a camera takes pictures before and after the injection. Expect a small needle prick and possibly brief throbbing at the injection site. Because the pupils are dilated, vision can stay blurry and light-sensitive for up to 12 hours, so arrange for someone to drive you home. The results are usually reviewed alongside other scans, such as optical coherence tomography (OCT), and often lead directly to a treatment decision. Some people with ongoing retinal conditions have repeat angiograms over time to track changes. An eye stain takes only a minute or two during an ordinary eye exam. Any blur from the dye clears quickly, and you can usually put contact lenses back in once the dye has been rinsed out or has cleared, as your examiner advises.

Questions to Ask Your Doctor

  1. 1.What are you looking for with this test, and how might the result change my treatment?
  2. 2.I had a reaction to fluorescein, or I have allergies or asthma. Is the test still the right choice for me, and what will you do differently?
  3. 3.Could another scan, such as OCT or OCT angiography, give you the information you need instead?
  4. 4.I am pregnant or breastfeeding. Should the test be delayed, or should I pause breastfeeding afterward?
  5. 5.When can I drive, return to work or wear my contact lenses again?

Last reviewed • Oct 2026

Educational content, not medical advice.