This test uses a special type of DNA called branched DNA to make a signal. Think of it like a chain reaction where one piece of DNA connects to a target, and then many copies of that DNA connect to a signal detector. This helps make the signal much stronger, making it easier to see even tiny amounts of the target.
Every report comes from a Lived member, sent anonymously.
No reports yet
Add what worked for you with the search bar below
A branched DNA test, often shortened to bDNA, is a laboratory method for measuring how much of a particular virus is in a blood sample. It works by attaching probes to the virus's genetic material and then building a branching chain of extra probes that each give off a signal. The lab amplifies the signal rather than copying the virus's genes, so the strength of the signal reflects how much virus was in the sample. That amount is called the viral load. The test has mainly been used for people already diagnosed with HIV (human immunodeficiency virus), to measure HIV in the blood before treatment and to check whether HIV medicines (antiretroviral therapy) are keeping the virus under control. Versions have also been used to measure hepatitis C and hepatitis B in people with those infections, to help decide on and follow treatment. Today most labs measure viral load with PCR-based tests (PCR stands for polymerase chain reaction), which copy the virus's genetic material before measuring it. From the patient's side the two feel the same: both start with a blood draw, and the lab chooses the method. Many people never learn which method their lab used, though it matters when comparing results over time.
No special preparation is usually needed. You can generally eat, drink and take your usual medicines unless your care team gives other instructions for tests drawn at the same visit. If you are living with HIV or hepatitis and have had viral load tests before, it helps to know where earlier samples were tested. Results are easiest to compare when the same type of test is done at the same lab each time, so mention any change of clinic or lab.
A health professional takes a small sample of blood from a vein in your arm with a needle. You may feel a brief sting as the needle goes in or comes out, and the draw itself usually takes less than five minutes. The measuring happens later in the laboratory, not while you are there. The sample is processed and tested with the branched DNA probes, and the lab reports the result as a number of virus copies (for HIV) or international units (for hepatitis C) per milliliter of blood.
You can return to normal activities right away. Slight soreness or a small bruise where the needle went in usually fades within a day or two. Results go to the clinician who ordered the test. For HIV, an undetectable result means there is so little virus in the blood that the test cannot find it. It shows treatment is working well and that HIV is unlikely to spread through sex, but it does not mean HIV is cured, and medicines need to continue to keep it that way. A rising or high viral load suggests the virus is multiplying and treatment may need to change. Small differences between two results can reflect normal variation in the test, so clinicians look at the trend across several results rather than a single number. For people with HIV, viral load is usually checked before starting treatment, about two to eight weeks after starting or changing medicines, and every three to six months once treatment is working well.
The physical risk is that of any blood draw: brief discomfort and occasionally a bruise at the needle site. The more practical limitation is interpretation. Different viral load methods, including bDNA and PCR-based tests, measure in slightly different ways and have different lowest levels they can detect. A switch from one method or lab to another can make a result look higher or lower without any real change in the infection. In one clinic study, people with stable HIV were more often reported as having a low but detectable level when their lab used PCR than when it used bDNA. That kind of shift can lead to extra testing or worry, which is why comparing results from the same test and the same lab gives the clearest picture.
Last reviewed • Oct 2026
Educational content, not medical advice.
Share your experience with Branched DNA Test, what to expect, or ask the community a question.