Blood Gas Analysis

This test measures the levels of oxygen and carbon dioxide in your blood. It helps doctors understand how well your lungs and heart are working to get oxygen into your blood and remove waste gases.

Procedure

What people who've had Blood Gas Analysis report

Every report comes from a Lived member, sent anonymously.

NameHow it went

No reports yet

Add what worked for you with the search bar below

About Blood Gas Analysis

Who It's For

Blood gas analysis is a blood test that measures how much oxygen and carbon dioxide are in the blood and how acidic the blood is, a value reported as pH. Together these numbers show how well the lungs are bringing oxygen in and clearing carbon dioxide out, and whether the body's acid-base balance, which the lungs and kidneys work together to keep steady, has shifted. The most common version is an arterial blood gas, or ABG, taken from an artery rather than a vein because arterial blood, freshly supplied by the lungs, shows oxygen levels more accurately. It is often ordered quickly in emergency departments, intensive care units and around surgery, for problems such as severe breathing difficulty, a serious asthma attack, sepsis (the body's dangerous reaction to infection), shock or diabetic ketoacidosis, in which the blood becomes acidic. It is also used to check whether oxygen therapy or BiPAP, a mask machine that helps with breathing, is working, and to monitor some long-term lung conditions such as chronic obstructive pulmonary disease (COPD). A venous blood gas, drawn from a vein, is sometimes used instead: its pH is close to the arterial value, but its oxygen and carbon dioxide readings are not reliable substitutes, so an arterial sample is still needed when those numbers matter.

Before the Procedure

There is usually no special preparation, and the test is often done during care that is already under way. Tell the person taking the sample if you take any blood-thinning medicine, including aspirin, because the puncture site may need longer pressure to stop bleeding. If you use supplemental oxygen, the setting is normally kept steady for about 20 minutes beforehand so the result reflects your usual breathing. Some tests are done on room air instead, with the oxygen briefly off, but only when that is safe for you. Before sampling from the wrist, the clinician may do a quick circulation check called an Allen test: you make a fist while they press on the wrist arteries, to confirm that blood flow to the hand is adequate.

During the Procedure

The sample is usually taken by a respiratory therapist, nurse or doctor from the radial artery on the inside of the wrist. The arm or groin is used less often, and newborns may be sampled from the heel or umbilical cord. You sit or lie down, the skin is cleaned, and a thin needle is placed into the artery, sometimes with ultrasound to locate it. A small amount of blood fills a syringe, and the needle is removed. The draw itself takes only a few minutes. An arterial draw usually hurts more than a routine blood test, because arteries lie deeper and are surrounded by nerves. Some people feel only a sting, others moderate pain, and a few feel lightheaded or nauseated.

Recovery & Aftercare

Firm pressure is held on the site for about five to ten minutes, longer for people on blood thinners, and a bandage is applied. Throbbing, soreness or a small bruise can follow and usually fades soon. Some providers suggest avoiding heavy lifting with that arm for about a day. If the site starts bleeding again, press firmly on it and let the care team know. Results come back quickly, often within 10 to 15 minutes, which is why the test is useful in urgent care. Typical values at sea level are a pH of about 7.35 to 7.45 (lower means the blood is too acidic, higher means too alkaline), an oxygen pressure (PaO2) of 75 to 100 mm Hg, a carbon dioxide pressure (PaCO2) of 35 to 45 mm Hg, bicarbonate of about 22 to 26 mEq/L, and oxygen saturation of 95 to 100 percent. Normal oxygen is lower at altitudes above about 3,000 feet, and ranges differ slightly between labs. The pattern matters more than any single number. Low oxygen points to a problem moving oxygen into the blood, high carbon dioxide suggests the lungs are not clearing it well enough, and an abnormal pH with a changed bicarbonate can reflect kidney, metabolic or medicine-related causes. Results are read alongside your symptoms and other tests, and the test may be repeated to see whether treatment is helping.

Risks & Complications

Blood gas analysis is low risk when done correctly. The main problems are local: pain, bruising, a collection of blood under the skin (a hematoma), bleeding that takes longer to stop, and, rarely, infection, as with any skin puncture. Some people faint or feel lightheaded. Because arteries vary in size and position, finding one can take more than one attempt. The other limitation is accuracy. Results can be misleading if oxygen settings changed shortly before the draw, which is why the sample is analyzed promptly and the oxygen setting is held steady beforehand, and a venous sample gives a much less reliable picture of oxygen and carbon dioxide than an arterial one.

Questions to Ask Your Doctor

  1. 1.Why do I need an arterial sample rather than a venous blood gas?
  2. 2.Should my oxygen be kept at its usual setting or turned off before the test?
  3. 3.Does my blood thinner change how the sample is taken or how long pressure is needed?
  4. 4.What do my oxygen, carbon dioxide and pH results show, and how do they fit with my other tests?
  5. 5.Will I need repeat blood gas tests, and what would change my treatment?

Last reviewed • Oct 2026

Educational content, not medical advice.